Windshield washer spray jets, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Fig 1: Unclipping Base Of Spray Jet From Bottom Of Hood

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip base of spray jet (bottom) from front hood - arrow -.

Fig 2: Identifying Hose, And Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove hose - 1 - from spray jet.
Where applicable, disconnect electrical connection - 2 -.

Installing

Install in reverse order of removal, noting the following:

When positioning hose, ensure it engages audibly in spray nozzle connection.

Fig 3: Locating Oval Opening For Spray Individual Nozzles

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place spray nozzles in hood so that oval opening - arrow - for individual spray nozzles face windshield.
When installing hose, ensure hose audibly engages in the connection on spray jet.