Rear window wiper motor, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove wiper arm → Rear window wiper arm, removing and installing .
Remove lower rear lid trim → 70 - INTERIOR TRIM .

Fig 1: Identifying Electrical Connection, Washer Fluid Hose, And Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection - 2 -.
Disconnect washer fluid hose - 1 - from connecting pipe for spray jet.
Loosen nuts - arrows - and detach wiper motor.

Installing

Install in reverse order of removal, noting the following:

Carefully insert rubber grommet into hole in rear window.

Fluid hose must audibly engage in spray jet connection.

Switch on ignition.
Actuate rear wiper and allow wiper motor to move to end position.

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Install lower rear lid trim → 70 - INTERIOR TRIM .
Adjust wiper arm → Rear window wiper arm park position, adjusting .

Component - fastener	Nm
Wiper motor to rear lid - nut	8