Headlamp washer spray jets, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Removing

Remove front bumper cover → 63 BUMPER .

Fig 1: Pulling Up On Spray Jet Covers At Bumper And Carefully Disengaging Mounts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull cover of spray jet upwards away from bumper cover and carefully disengage retainers - arrow -.

Fig 2: Identifying Washer Fluid Hose, And Spray Jet Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release clamp and remove hose - 3 -.
Remove screws - 1 - and - 2 - and detach spray jet.

Installing

Install in reverse order of removal, noting the following:

Install front bumper cover → 63 BUMPER .

Tightening torque

Component - fastener	Nm
Spray jet to bumper cover - screw	3