Engine Coolant Temperature (ECT) Sensor G62 - 2.0L 4-cylinder Turbo FSI engine, multi-pin connector assignments

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Preparations

Location: on rear right of engine.

Fig 1: Disconnecting Electrical Harness Connector From Engine Coolant Temperature (ECT) Sensor G62

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection at sensor - 1 -.

Fig 2: Identifying 2-Pin Electrical Harness Connector & Terminals

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pin assignment for 2-pin connector on Engine Coolant Temperature (ECT) Sensor G62

Wiring from sensor to instrument cluster (temperature gauge)
Ground (GND) ( - )