Starter - 2.0L 4-cyl Turbo FSI engine, removing and installing

Special tools, testers and auxiliary items required 

Fig 1: Identifying Torque Wrench V.A.G. 1331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• VAG 1331 Torque wrench (or 5 - 50 Nm equivalent)

Fig 2: Identifying Torque Wrench V.A.G. 1332

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• VAG 1332 Torque wrench (or 40 - 200 Nm equivalent)

Removing 

• Disconnect battery → Battery in engine compartment, disconnecting and reconnecting .
• Lift vehicle.

Fig 3: Identifying Quick-Release Fasteners And Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Release fasteners - 1  - and - 2  - and remove front noise insulation.

Fig 4: Removing Left/Right Heat Shields For Drive Axles

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove heat shield - 1  - for right drive shaft.

Fig 5: Identifying Bolts And Starter

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - 1  - and - 2  -.

Fig 6: Identifying Starter, Electrical Connector & Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove starter and swing aside.
• Disconnect electrical connection for terminal 50 - 3  -.
• Remove nut - 1  - for harness clamp.
• Remove nut at starter solenoid terminal B+ - 2  - and remove connector eyelet from terminal.

• Remove starter.

Installing 

Install in reverse order of removal, noting the following:

• Reconnect battery. Required steps Reconnecting .

Tightening torques