Generator (GEN) - 3.0L 6-cylinder engine, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect battery → Battery in engine compartment, disconnecting and reconnecting .

Fig 1: Removing Front Engine Cover

GW00017571

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove front engine cover - arrows -.

CAUTION: Before removing ribbed belt, mark direction of rotation. Belt damage will result if not reinstalled in proper direction.

Fig 2: Swinging Ribbed Belt Tensioner To Release Tension On Ribbed Belt

GW00017606

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Relieve ribbed belt tension by turning tensioner in direction of - arrow -.
Remove ribbed belt from power steering pump pulley.
Lift vehicle.

Fig 3: Identifying Quick-Release Fasteners And Noise Insulation

GW00017429

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release fasteners - 1 - and - 2 - and remove front noise insulation.

Fig 4: Starter Wiring Bracket Cable Ties

GW00004755

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove cable ties - arrows - , unclip cover for starter cable guide harness and remove harness from guide.

Vehicles with automatic transmission:

Fig 5: Unscrewing Nut For Clamp For ATF Lines

GW00019371

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nuts - 1 - and - 2 -.
Remove bracket for ATF lines.

All models:

Unclip refrigerant line from bracket at sump.
Disconnect electrical connections at generator.
Remove bolts - arrows -.

Fig 6: Identifying Bolts And Generator

GW00017610

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove generator.