Telephone Transceiver R36 , removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.

Use the Vehicle Diagnosis, Testing and Information System VAS 5051 to do so.

Turn off all electrical components.
Remove ignition key.

Removing

Remove right A-pillar trim → - 70 - INTERIOR TRIM .
Remove right front seat → - 72 - SEAT - FRAMES .

NOTE:

Safety belt on seat frame must not be loosened.
Fold back the floor mat → - 70 - INTERIOR TRIM .

Fig 1: Identifying Passenger Side Electronics Box Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release electronics box cover - arrows - and remove it.

Fig 2: Identifying Connectors And Telephone Transceiver R36

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connectors - 1 - and - 3 - on Telephone Transceiver R36 - 2 -.
Pry Telephone Transceiver R36 - 2 - out of E-box.
If present, remove Bluetooth Antenna R152.

Installing

Install in reverse order.