LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Communication) >> 91 - Communication >> Telephone system - USA >> Connectors and connector assignments >> Telephone Transceiver R36

Telephone Transceiver R36

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Telephone Transceiver R36 (Cell Phone Preparation), From MY03
GW00021447Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connectors

A - Bluetooth Antenna R152 connection (yellow)

B - Black 54-pin multi-pin harness connector

NOTE:
  • Unlisted connector terminals are not assigned.
Fig 2: Telephone Transceiver R36 (Cell Phone Preparation), From MY03
GW00021447Courtesy of VOLKSWAGEN UNITED STATES, INC.

B - Black 54-pin multi-pin harness connector

1 - Terminal 30

2 - Terminal 31

8 - NF (+) out to Radio R / Navigation System with CD Drive Control Module J401

9 - NF (-) out to Radio R / Navigation System with CD Drive Control Module J401

10 - Terminal 31 (screen ground) (not used)

11 - Microphone input (+) Telephone Microphone R38 / Navigation System with CD Drive Control Module J401

12 - Microphone input (-) Telephone Microphone R38 / Navigation System with CD Drive Control Module J401

15 - K diagnostic

16 - NF mute to Radio R / Navigation System with CD Drive Control Module J401

17 - CAN-Bus High (Infotainment)

18 - CAN-Bus Low (Infotainment)

37 - Terminal 30 to Telephone Baseplate R126

39 - Terminal 31 to Telephone Baseplate R126

41 - Terminal 30 to Telephone Baseplate R126

42 - Microphone output (+) to Telephone Baseplate R126

43 - Microphone output (-) to Telephone Baseplate R126

44 - Terminal 31 (screen ground)

45 - LF input (+) from Telephone Baseplate R126

46 - LF input (-) from Telephone Baseplate R126

47 - SNDREQ signal from Telephone Baseplate R126

49 - Ser-Tx (+) to Telephone Baseplate R126

50 - Ser-Tx (-) to Telephone Baseplate R126

51 - Ser-Rx (+) from Telephone Baseplate R126

52 - Ser-Rx (-) from Telephone Baseplate R126