Antenna Splitter R87 - Avant, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Switch off all electrical components.
Switch ignition off and remove ignition key.

Removing:

Remove A-pillar trim: → - 70 - INTERIOR TRIM .
Remove front passengers seat → - 72 - SEAT - FRAMES .

NOTE:

Seat belt need not be removed from seat frame.
Pull back floor carpet..

Fig 1: Identifying Passenger Side Electronics Box Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release cover for electronics box - arrows - and remove.

Fig 2: Opening Lid Of Mounting Box

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Open lid - 1 - of mounting box - 2 - in direction of - arrow -.
Disconnect antenna cable connections and remove splitter.

Installing:

Install in reverse order of removal, noting the following:

NOTE:

Ensure correct seating and fit of electrical connections.
Antenna connections (couplings) must be properly aligned and tight to ensure proper reception.