iPod Baseplate R192

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Unlisted connector terminals are not assigned.

Fig 1: Ipod Baseplate R192 12-Pin Multi-Pin Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Black 12-pin multi-pin harness connector (T12a)

1 - Data out to Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

2 - CLK out to Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

3 - Terminal 31

4 - Data in from Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

6 - Permanent positive from Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

7 - Right signal to Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

8 - Positive switched from Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

9 - Signal ground from Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

10 - Left signal to Radio R / Operating Electronics, Navigation Control Module J402 / Radio/Navigation Display Control Module J503

11 - TOC Check Control (not used)

12 - Terminal 58 (not used)