"Symphony II+" in transport mode, activating/deactivating
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Transport mode must be activated before sending every "Symphony II+" radio.
After activation, the internal CD changer drive is in transport position.
After replacing a "Symphony II+" , transport mode must be deactivated after installation.
Transport mode, activating
"Symphony" is connected and installed.
- Press station buttons 3 and 5 and TONE button at the same time.
After about 5 seconds, "TRANSPORT" appears on the radio display.
Transport mode, deactivating
" II+Symphony" is connected and installed.
- Press CANCEL button.
"TRANSPORT" display goes out.
Transport mode is deactivated.