LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Communication) >> 91 - Communication >> Navigation system IV (BNS 4.0) >> General information

General information

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Disconnect battery ground wire before working on electrical system.

On vehicles with Telematics, activate Telephone/Telematics Control Module J526 service mode before disconnecting Battery A → Service mode, activating/deactivating .

If the Battery A is reconnected, follow the procedure for disconnecting and connecting the Battery A → - 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL . Deactivate Telephone/Telematics Control Module J526 service mode → Service mode, activating/deactivating .

Description 

BNS 4.0 (Nav IV) navigation system is an enhancement of the established navigation system III.

Important improvements are, e.g. connection to CAN BUS (Infotainment) and dynamic route guidance.

The navigation system receives the information for dynamic route guidance from the Radio R TMC function or via the Telephone Transceiver R36.

The system consists of:

Diagnosis is performed using "Guided Fault-Finding".

Repairs on antenna wires → - 97 WIRING .

Repair to CAN bus lines → - 97 WIRING .