Function Selector Switch II E272 , removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Turn off all electrical components.
Remove ignition key.

Removing

Fig 1: Identifying Cigarette Lighter Cover And Function Selector Switch II E272

GW00021472

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Open cigarette lighter cover - 2 -.
Press Function Selector Switch II E272 - 1 - out of installation opening from below as shown in illustration.
Disconnect connector at Function Selector Switch II E272.

Installing

Install in reverse order.