General information
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Disconnect battery ground wire before working on electrical system.
- On vehicles with Telematics, activate Telephone/Telematics Control Module J526 service mode before disconnecting Battery A → Service mode, activating/deactivating .
If the Battery A is reconnected, follow the procedure for disconnecting and connecting the Battery A → - 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL . Deactivate Telephone/Telematics Control Module J526 service mode → Service mode, activating/deactivating .
Description
The starting position, mileage driven and destination are transferred via the navigation system II-D, through the CAN BUS (Infotainment) and to the Chip Card Reader R99 (electronic route book) and saved on the card chip.