Oil pressure and oil pressure switch, checking
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and equipment
- VAG1342 Oil pressure gauge
- VAG1527B Voltage tester
- VAG1594A Connector test kit
Requirements
- Oil level OK
- Engine oil temperature approximately 80 C.
- With ignition on, Oil pressure warning light -K3- must be lit.
- For vehicles with Auto Check System, "OK" indicator must be lit (call up symbol).
Oil pressure switch, checking
- For vehicles with auxiliary heater, remove bolts (arrows) for exhaust pipe of auxiliary heater on sound insulation.
- Remove bolts or quick-release screws -1- and -2- and remove front sound insulation.
- Disconnect electrical harness connector at oil pressure switch (arrow).
- Remove oil pressure switch and install VAG1342 oil pressure tester.
- Install oil pressure switch -2- on VAG 1342.
- Connect brown wire -1- of tester to ground (GND).
- Using VAG1594A connector test kit, connect VAG1527B voltage tester to oil pressure switch and Battery positive (+).
- LED must not be lit
If LED is lit:
- Replace oil pressure switch.
- Start engine.
NOTE:
While starting engine, watch pressure tester and LED as oil pressure switch may open during start.
Black oil pressure switch
- At 1.2 to 1.6 bar pressure, LED must light up
If LED does not light up:
- Replace oil pressure switch.
Oil pressure, checking
- Disconnect electrical wire from oil pressure switch.
- Remove oil pressure switch and install VAG1342 oil pressure tester.
- Install oil pressure switch -2- on VAG 1342.
- Start engine (engine oil temperature approximately 80°C).
- Oil pressure at idle: at least 1.5 bar
- Oil pressure at 2000 RPM: at least 3.0 bar
If specified values are not obtained:
- Pressure relief valve or oil pump faulty, replace oil pump.