Right cylinder head cover, removing and installing: Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

NOTE:

Always replace self-locking bolts.
Replace cylinder head cover gasket if damaged.

Fig 1: Right Cylinder Head Cover Tightening Sequence

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tighten cylinder head cover in sequence -1- to -12-.

Fig 2: Identifying Exhaust Pipe Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

For vehicles with auxiliary heater, remove bolts (arrows) for exhaust pipe of auxiliary heater on sound insulation.

Fig 3: Identifying Quick-Release Fasteners And Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts or quick-release screws -1- and -2- and remove front sound insulation.
Replace O-ring at guide tube for oil dipstick and insert guide tube into hole in oil pan (upper part).