Damper unit, removing and installing: Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order, paying attention to following:

NOTE: The part number of the damper unit is assigned to the transmission code letter.

Fig 1: Unscrewing/Screwing Bolts And Removing/Installing Damper Unit From Flywheel

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Align damper unit -A- with flywheel -B-.

Two lugs -2- must line up with each other

Hand-tighten bolts -1- (9 pcs.).
Tighten bolts to 25 Nm in diagonal sequence.