Ribbed belt for power steering pump, generator and A/C system
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before removing ribbed belt, note direction of rotation with chalk or felt-tip marker. Reversing the direction of rotation of a run-in belt can destroy the belt.
1 - Ribbed belt
- Removing and installing. Refer to Ribbed belt, removing and installing
- Check for wear
2 - 23 Nm
3 - Generator
- Removing:
Refer to 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
4 - 45 Nm
5 - 23 Nm
6 - Bracket
- For generator
7 - 40 Nm
8 - Ribbed belt tensioner
- Removing and installing. Refer to Ribbed belt tensioner, removing and installing .
9 - 23 Nm
10 - Belt pulley
- For power steering pump
- Use 3212 spanner wrench to counterhold when removing and installing
- Identification: Front
11 - Seal
- Always replace
12 - Banjo fitting, 47 Nm
13 - Pressurized line
- To power steering
14 - Power steering pump
- Removing and installing:
Refer to 48 - STEERING
15 - Bracket
- For power steering pump
16 - 23 Nm
17 - 23 Nm
18 - Bracket
- For A/C compressor
19 - 23 Nm
20 - 23 Nm
21 - 25 Nm
22 - A/C compressor
- Do not unscrew or disconnect refrigerant lines
- After removing, secure compressor to chassis (i.e. with wire) Do not hang on refrigerant lines
23 - Socket
- For A/C compressor
- 2x
24 - Harmonic balancer
- Version dependent with/without thrust washer between harmonic balancer and toothed belt gear. Refer to Vibration damper, removing and installing
- Removing and installing. Refer to Vibration damper, removing and installing
25 - 23 Nm
26 - 23 Nm