Drive plate with overload protection, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Install drive plate with overload safeguard - B - to drive plate - C -.
- Insert and hand-tighten bolts - A -.
- Check run-out of drive plate - B - → Run-out of drive plate with overload protection, checking and adjusting .
- Tighten bolts - A - (tightening torque 10 Nm).
- Check run-out of drive plate - B - again → Run-out of drive plate with overload protection, checking and adjusting .