Compressor drive shaft, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order, paying attention to the following:

Check drive shaft - B -. Splines must not show signs of wear and must engage snugly in splines of drive pinion - C -.
Before installing, coat splines of drive shaft - B - with special grease G 000 100.

Fig 1: Removing/Installing Boot & Pulling Drive Shaft Out/In Of Splines Of Drive Pinion

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Before installing compressor, insert drive shaft - B - and slide it home in drive pinion - C -.
After installing compressor, check installation position of socket - A -.