Belt pulley, removing from compressor and reinstalling (version "2"): Notes

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Observe notes on removal of version "1" pulley, as these also apply to version "2" → Belt pulley, removing from compressor and reinstalling (version "1") .
Perform preparatory work as described for removing version "1" pulley → Belt pulley, removing from compressor and reinstalling (version "1") .
Belt pulley is made of plastic, is sensitive to impact and should be treated with extreme care.

Fig 1: Ribbed Belt Pulley - "Denso" A/C Compressor Remove/Install Components (1 Of 2)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If overload safeguard of drive plate - C - has been triggered, remove securing ring - A - and then pry drive plate off pulley - D -.