Right Footwell Vent Temperature Sensor G262, removing and installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Remove operating and display module, Climatronic Control Module J255.

Fig 1: Right Footwell Vent Temperature Sensor G262, Removing/Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Reach through opening for operating and display module, Climatronic Control Module J255 and disconnect connector - A -.
Give Right Footwell Vent Temperature Sensor G262 - B - approx. 90° turn in direction of arrow.
Pull Right Footwell Vent Temperature Sensor G262 out of air conditioner.

NOTE:

observe arrangement of connectors to both sensors (Left Footwell Vent Temperature Sensor G261 and Right Footwell Vent Temperature Sensor G262 to avoid interchange).