Fresh Air Blower Control Module J126 and Fresh Air Blower V2, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Remove glove compartment →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
.

Fig 1: Disconnecting Connector & Cable Ties

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connector - A -.
Remove lower "A-pillar" trim →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
.
Loosen cable ties - B -.

Fig 2: Removing Air Conditioner Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - A -.
Pull air conditioner slightly to rear.
Carefully fold back floor covering.

Fig 3: Identifying Fresh Air Blower V2 & Rear Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press noise insulation mat aside until rear bolt - C - is accessible.
Remove bolts - C -.
Push noise insulation mat aside and pull Fresh Air Blower V2 - D - out of air conditioner.

NOTE:

The Fresh Air Blower V2 contains the Fresh Air Blower Control Module J126 as an integral component which cannot be replaced separately.
When installing, pay attention to correct positioning of Fresh Air Blower V2 in air conditioner.