Third rear three-point seat belt (folding rear seat backrest), removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Torque wrench V.A.G 1332
1 - Screw
- Tightening torque 55 Nm
2 - Nut
- Tightening torque 55 Nm
3 - Belt tensioner
4 - Belt relay
5 - Belt webbing
6 - Belt guide cover
7 - Screw
- Tightening torque 55 Nm
8 - Retaining tab
9 - Belt tensioner connector
10 - Retaining tab
11 - Retaining tab
12 - Bracket to rear seat backrest
13 - Cut-out
- Removal:
- Remove rear seat bench: Vehicles through 10.04 → Seatbench, removing and installing - vehicles up to 10.04 , vehicles from 11.04 → Seatbench, removing and installing - vehicles from 11.04 .
- Remove bolts - 7 -.
- Remove 2/3 rear seat backrest → 2/3 right backrest, removing and installing .
- Press cover with belt guide cover - 6 - to side and pry retaining tab - 11 - out with a screwdriver.
- Remove cover - 6 - in direction of arrow - A -.
- Remove 2/3 rear seat backrest upholstery until you can remove anchor with upholstery.
- Remove bolt - 1 - (Qty. 1).
- To disconnect harness connector - 9 -, open retainer using a screwdriver (USA).
- Remove nut - 2 - (Qty. 1).
- Remove third rear three-point seat belt - 3 -.
- Installing:
- To install belt guide cover - 6 -, retaining tab - 10 - must first be positioned and inserted, then retaining tab - 11 - must be rotated inward while panel - 12 - is guided into cut-out - 13 - on belt guide cover - 6 - - arrow B - (magnified area).
- Ensure connector - 9 - (USA) is engaged correctly.
- Clip belt guide cover - 6 - in by tapping lightly with hand in direction of arrow - C -.
- On vehicles with belt tensioners, belt wear detection must be checked → Checking belt holding sensor for rear three-point seatbelt with belt tensioner .
NOTE:
- The belt relay - 4 - and belt webbing - 5 - must not touch or graze foam pieces or anchor pieces.
- Belt relay - 4 - must follow each belt webbing movement.
- Belt webbing - 5 - must move freely in all directions.