Installing rear window

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

After preparatory work has been performed, apply the adhesive.

Fig 1: Positioning Complete Surface Of Nozzle Onto Window

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Position complete surface of nozzle - 2 - onto window.
- Arrow - indicates direction of application

NOTE:

Cross-section thickness of adhesive bead - 1 - is determined by dimension of opening in nozzle tip and rate of application.

Fig 2: Applying Adhesive Sealing Material All Around

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Apply adhesive sealing material all around, as shown in illustration.
Note varying spacing dimensions to window edge → Rear window (Sedan), removing and installing .
Using two double suction cups, install rear window in window opening.

CAUTION: Window must be installed within 15 minutes, otherwise bonding properties of adhesive will be impaired.

Align windshield at sides.
Spacing between edge of window and roof frame must be 6.5 mm.
Observe curing time.