Assembly overview
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Rear window
- Removal → Undamaged rear window, removing
- When installing, note direction of joint - arrow - in magnified area of illustration.
- After inserting window, pull up to dimension - a - = 6.5 mm at roof.
- Align window at sides.
2 - Adhesive end profile
- Adhere next to vertical rear window defrosting strips
- Adhesive must not touch distributing wire for rear window defroster.
3 - Adhesive bead
- Note varying spacing dimensions to window edge.
- The dimensions - b - and - c - are achieved when you allow the application nozzle to touch each inner edge of the molding.
- The distance to lower window edge dimension - d - is 15mm.
- Bead cross section
- Bead width = 8 ± 2 mm
- Bead height = 13.5 ± 1.5 mm
4 - Spacers
- Note different heights for standard glass and tinted glass.
- Place spacers at distance of 3mm to lower window edge onto markings applied in ceramic screen printed area.