Shock absorber, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Bumper removed.

Fig 1: Shock Absorber Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove combination bolts - 2 -.
Unscrew nut - 3 - and pull shock absorber - 1 - from longmember.
When installing, tighten combination bolts - 2 - to 50 Nm and hex nut - 3 - to 4 Nm.