Adjusting support piece
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Before installing bumper cover - 1 - , adjust adjustment screw - 3 - for support piece - 5 - to dimension - a - = 21 mm +1 mm.
- Mounting bracket - 4 - must be screwed on completely (left-hand thread) for this.
- Adjustment screw - 3 - and mounting bracket - 4 - belong to delivery casing for support piece - 5 - , there are no replacement parts.
- While screwing in bolt - 3 - , mounting bracket - 4 - screws out and holds the carrier part - 2 - of bumper cover - 1 - in the designated position.
- Support piece - 5 - is secured to bumper - 6 - with pop rivets.