Fender, removing and installing: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Bolts and washers are micro-encapsulated and must be replaced after loosening or after removing the fender.
Up to Vehicle Identification Number (VIN) 400 000
1 - Fender
- Remove bumper → Front bumper, removing and installing .
- Remove wheelhousing liner → Wheelhousing liner, removing and installing .
- Remove end plate → Removing and installing end plate .
- Remove headlight. Refer to
- 94 LIGHTS, SWITCHES - EXTERIOR
- 94 LIGHTS, SWITCHES - EXTERIOR for ELECTRICAL EQUIPMENT, CABRIOLET
- Disconnect electrical connectors for the side blinkers.
2 - Combination bolt
- 8 Nm
3 - Combination bolt
- 10 Nm
4 - Combination bolt
- 10 Nm
5 - Combination bolt
- 10 Nm
6 - Combination bolt
- 10 Nm
7 - Bracket
8 - Combination bolt
- 10 Nm
As of Vehicle Identification Number (VIN) 400 001
1 - Brace for wheelhousing liner
2 - Combination bolt
- 10 Nm
3 - Brace for fender
4 - Combination bolt
- 10 Nm
5 - Torx screw
- 10 Nm
6 - Combination bolt
- 8 Nm
7 - Wheelhousing liner
- Removed
8 - Combination bolt
- 10 Nm
9 - Fender
- Remove bumper → Front bumper, removing and installing .
- Remove wheelhousing liner → Wheelhousing liner, removing and installing .
- Remove end plate → Removing and installing end plate .
- Remove headlight. Refer to
- 94 LIGHTS, SWITCHES - EXTERIOR
- 94 LIGHTS, SWITCHES - EXTERIOR for ELECTRICAL EQUIPMENT, CABRIOLET
- Disconnect electrical connectors for the side blinkers.
- Remove bolts - 5 - ; - 6 - and - 8 - and remove fender.