Cowl panel trim, removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Cowl trim
- Windshield wiper arms removed.
- Plenum chamber cover removed.
- Pull out securing pins - 4 -.
- Remove trim from retaining strip at windshield, bottom.
- Remove trim upward.
- When installing, make sure that the trim engages completely into retaining strip.
2 - Support
3 - Windshield
4 - Securing pin
5 - Plenum chamber cover
- Remove gasket - 6 - and remove cover from cowl panel trim
6 - Gasket