Tire Pressure Monitoring Control Module J502 , removing and installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Tire Pressure Monitoring Control Module J502 is located behind side trim at left of luggage compartment.

Remove side trim at left of luggage compartment.

Fig 1: Unclipping Control Module, Disconnecting Connector And Removing Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip control module - 1 -.
Disconnect connector - 2 - and remove control module.

Installing

Installation is in reverse order of removal.