Vehicle level sensor in vehicle, replacing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Torque wrench V.A.G 1331

Remove tire.

Fig 1: Removing/Installing Bolts With Angled Wrench

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolt - 1 -.
Remove bolts - 2 - with angled wrench. When doing so, do not bend upper retaining plate.

Transverse control arm is not shown.

Adapt replacement part accordingly and install.

NOTE:

Hold Level Control System Sensor securely when tightening bolts - 2 -.

Torque specifications:

- Item 1: 10 Nm

- Item 2: 5 Nm

After replacing, perform basic setting for headlights. →
- 94 LIGHTS, SWITCHES - EXTERIOR
- 94 LIGHTS, SWITCHES - EXTERIOR for ELECTRICAL EQUIPMENT, CABRIOLET
Mount wheel and tighten. This information is contained in AESIS; Library; Additional Information; Wheels and Tire Guide