Removing and installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1332

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1332

Fig 2: Torque Wrench V.A.G 1410

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1410

When removing and installing control arm, it is necessary to loosen Left Front Level Control System Sensor G78 retaining clip.

NOTE:

To install connecting link to Left Front Level Control System Sensor G78 crank, use an open-end wrench (wrench width 10) with dimension - A - = 4 mm to avoid damaging the seal.

Fig 3: Linkage Attached To Sensor And New Transverse Link Installed

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Dimension - A - = 4 mm
Mount wheel and tighten. This information is contained in AESIS; Library; Additional Information; Wheels and Tire Guide
Left Front Level Control System Sensor G78 connecting link retaining clip is secured at control arm between stops with a clamp.

When installing headlight range control, ensure correct position of crank and connecting link to each other.

NOTE:

Connecting link must face forward diagonally.
Crank must face rearward.