LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Suspension, Wheels, Steering) >> 00 - Technical data >> Technical data >> Suspension

Technical data: Suspension

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Front axle Four-link lightweight suspension with virtual steering axis, transverse stabilizer, twin gas-filled struts and coil springs, control arm with hydraulic damping mounts
Rear axle Trapezoidal control arm - rear axle, independent suspension

Vehicles up to VIN 400 000 

    Front Wheel Drive (FWD)/All Wheel Drive (AWD)
Model:   Sedan/Wagon Convertible
  Standard suspension 1BA Sport suspension 1BE Sport suspension 1BV (quattro GmbH) Audi S4 1BD Comfort heavy duty suspension 1BR Standard suspension 1BA Sport suspension 1BE
Wheelbase: mm 2645 2651 2642 2650
Front track mm 1524 1 * See note 1528 1 * See note 1521 1 * See note 1522 2 * See note
Rear track mm 1517 1 * See note 1523 1 * See note 1513 1 * See note 1517 2 * See note
Maximum steering angle at inner wheel Degree 38 38 38 38

*1 These specified values correspond to a wheel offset of ET 39 mm and a load condition "empty without driver".

*2 These specified values correspond to a wheel offset of ET 42 mm and a load condition "empty without driver".

Vehicles from VIN 400 001 

Front Wheel Drive (FWD)/All Wheel Drive (AWD)
Model:   Sedan/Wagon
    Standard suspension 1BA Sport suspension 1BE Sport suspension 1BV (quattro GmbH) Audi S4 1BD Comfort heavy duty suspension 1BR Basic suspension 2MC (quattro GmbH RS4) Sport suspension 2ME (quattro GmbH RS4)
Wheelbase: mm 2644 2649 2640 2649 2652
Front track mm 1522 1 1524 1 1517 1 1523 1 1525 1
Rear track mm 1515 1 1521 1 1510 1 1533 1 1535 1
Maximum steering angle at inner wheel Degree 38 38 38 38 38

*1 These specified values correspond to a wheel offset of ET 42 mm and a load condition "empty without driver".

NOTE:
  • The specified values apply to all engine versions.
  • Tracks change with use of wheels with different offset.