Ball head, adjusting
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Adjusting ball head
a = 159 mm ± 0.5 mm
NOTE:
- Surface - 1 - for measuring
- The ball head must be set at right angles to the surface of the brake booster when taking the measurement.
- Measure to end of ball head without gasket installed.
Tightening torque for ball head to brake booster: 30 Nm