Brake system vacuum pump V192 , removing and installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

The vacuum pump is not intended to be serviced. If problems occur, trace the malfunction by means of a function test and/or pressurized leak test. If a malfunction is found, the brake system vacuum pump V192 must be replaced.

Removing:

Remove trim cover.

Fig 1: Disconnecting Electrical Connector & Vacuum Hose From Vacuum Pump

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 2 -.
Disconnect vacuum hose - 1 - from vacuum pump.

Fig 2: Identifying Brake System Vacuum Pump V192

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press clip out of bracket by hand.
Lift out brake system vacuum pump V192.

Installing

Installation is in reverse order of removal.