Brake caliper, servicing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Install complete repair kit when servicing.
- Apply thin coat of lithium grease G 052 150 A2 to brake cylinder, piston and seal.
1 - Brake carrier
- Bolt to brake caliper housing
2 - Guide pins, 30 Nm
3 - Dust cap
- Insert into bushing
4 - Protective cap
- Push onto bleeder valve
5 - Bleeder valve, 15 Nm
- Apply thin coat of lithium grease G 052 150 A2 before screwing in
6 - Bearing bushing
- Insert into brake caliper housing
7 - Brake caliper housing
8 - Retaining spring
- Note correct installation position.
- Engage onto both brake caliper housing studs and onto outer pad retaining spring.
9 - Protective seal
- Do not damage when inserting piston
- Apply a thin coat of lithium grease G 052 150 A2
10 - Piston
- Apply a thin coat of lithium grease G 052 150 A2 to piston
11 - Seal
- Apply a thin coat of lithium grease G 052 150 A2