Brake light switch, removing and installing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Remove brake light switch to adjust.
To ensure a secure fit, the switch may only be installed once.

Removing

Disconnect electrical connector.
Turn brake light switch counter-clockwise 45° to remove.

Installing

Installation is in reverse order of removal. Note the following:

Fig 1: Pulling Out Switch Plunger & Identifying Retainer Tabs On Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull out brake light switch plunger as far as it will go - arrow -.
Insert switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.
Remove driver side storage tray: →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET

NOTE:

The brake pedal must not be actuated during installation.
When installing brake switch, plunger adjusts itself automatically.

Fig 2: Guiding Switch Through Installation Hole, Pressing Against Pedal And Securing By Turning 45° Clockwise

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Guide switch through installation hole, press against pedal and secure by turning 45° clockwise.

After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).