Input shaft with 7 lining discs, assembly overview

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Note the difference between input shafts with 6 and 7 lining discs → Input shaft, servicing with 7 lining discs

Fig 1: Input Shaft With 7 Lining Discs, Assembly Overview

GW00019579

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Input shaft seal

Replace → Input shaft seal, replacing

2 - Input shaft cover circlip

Replace with same thickness

3 - Input shaft cover

After removing cover, input shaft cover ball bearing must be replaced → Ball bearing in input shaft cover, replacing

4 - Piston

Check for wear → Transmission components, evaluating wear

5 - Pressure plate

Check for wear → Transmission components, evaluating wear

6 - Corrugated spring washer

7 - Upper adjustment disc

Determine thickness → Input shaft with 7 lining discs, adjusting with air gap determination
Replace

8 - Coated plate

Qty. 7
Replace

9 - Outer plate

Qty. 6
Replace

10 - Lower adjustment disc

Determine thickness → Input shaft with 7 lining discs, adjusting with air gap determination
Replace

11 - Input shaft cylinder

Check for wear → Transmission components, evaluating wear

12 - O-Ring

Replace

13 - Oil pipe

Check for wear → Transmission components, evaluating wear