Selector shaft, cleaning

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Rules of cleanliness for working on automatic transmissions → Rules for cleanliness when working on transmission .
General repair notes → Repair instructions .
Transmission Control Module (TCM) J217 removed

Work procedure

Fig 1: Identifying Catch Of Selector Shaft, Spring & Roller

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Clean catch - arrow - of selector shaft. Do not use fluffy materials for cleaning. Clean contact surfaces of magnet especially thoroughly of metal shavings and the like.

NOTE:

Make sure that spring - A - and roller - B - are secured properly.

Fig 2: Identifying Sensors Of Soiling And Metal Shavings

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If necessary, clean sensors - A - , - C - and - D - of soiling and metal shavings.
Install Transmission Control Module (TCM) J217 → Transmission Control Module (TCM) J217 , removing and installing .