Check locking button on selector lever handle
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Check locking button for ease of movement:
- It must be possible to press locking button without great force.
- After releasing, the locking button must come all the way back out by itself
If specified values are not obtained:
- Check whether selector lever handle is installed correctly.
- Check whether selector rod or selector lever is bent.
Function test:
- Ignition switched on
Locking button on selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into specified position.
- "P" to "R" and also press brake pedal
- "D" to "S"
- "N" to "R" ; in standstill, also press brake pedal after long wait
- "R" to "P"
If specified values are not obtained:
- Check whether selector lever handle is installed correctly.
- Adjust selector lever cable → Selector lever cable (through VIN 8E_6A156499), adjusting .