Selector lever cable (from VIN 8E_6A156500), adjusting

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Socket And Key T40031

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Socket and key T40031

Fig 2: Releasing Clips And Pull Cover With Guide Upwards To Remove

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove cover for shift mechanism → Shift mechanism cover (from VIN 8E_6A156500), removing and installing .
Place selector lever in position "D".

Fig 3: Locating Rear Clamping Screw On Selector Lever Cable Approx. 1 Turn Through Hole In Shift Mechanism Using Special Tool T40031

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen rear clamping screw on selector lever cable through hole in shift mechanism approx. one turn using socket and key T40031.

NOTE:

Loosen clamping screw only approx. 1 turn. Do not remove.
Clamping screw is only accessible in selector lever position "D".
Selector lever must remain in position "D" while clamping screw is loose.

Carefully move selector lever lightly toward front and rear without shifting into another selector lever position, this releases the tension on selector lever cable.
Check exact position of selector lever in position "D" by pushing selector lever lightly towards drivers seat - arrow A -.

NOTE:

Do not touch selector lever during the adjustment.

Without touching selector lever, tighten clamping screw in this position using socket and key T40031.
Install cover for shift mechanism → Shift mechanism cover (from VIN 8E_6A156500), removing and installing .
Check shift mechanism → Shift mechanism (from VIN 8E_6A156500), checking .

Fig 4: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Using Vehicle Diagnosis, Testing and Information System VAS 5051 A , the position of Multi-Function Transmission Range (TR) Switch F125 can be compared to position on selector lever via On Board Diagnostic (OBD), 02 - Transmission electronics, 08 - Read measured value block, display group 2 in display field - 1 -.

If shift mechanism does not function properly after adjusting selector lever cable:

Bring selector lever cable into basic setting → Selector lever cable, from VIN 8E_6A156500), bringing into basic setting .

Torque specifications

Component	Nm
Clamping screw to selector lever cable	13