Front final drive gear oil level, checking
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Safety goggles
Condition
- Gear oil about 20° C (room temperature)
Work sequence
- Drive vehicle onto a four-column lifting platform or over an inspection pit in order for it to be absolutely horizontal.
- Place drip tray V.A.G 1306 under the transmission.
CAUTION:
Wear safety goggles.
- Remove plug - arrow -.
- Oil level must be up to lower edge of filler hole.
- Drain off any excess oil or top off to proper level; specification → Capacities .
NOTE:
- The plug with seal must be replaced.
- Tighten new plug to 35 Nm.