Shift lock solenoid N110, removing and installing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove selector mechanism cover → Selector mechanism cover, removing and installing .

Fig 1: Releasing Lugs And Selector Lever Lock Solenoid Forward

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector at Shift lock solenoid N110.
Release retainer and pull out Shift lock solenoid N110 from front - arrows -.

Fig 2: Pressing Selector Lever Lock Solenoid Into Guide Until It Engages

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Installation is performed in reverse sequence. Note the following:

Press Shift lock solenoid into guide until it engages. Actuating lever - 2 - for solenoid must engage in locking lever - 1 - on selector mechanism.
Install selector mechanism cover → Selector mechanism cover, removing and installing .