Multi-Function Transmission Range (TR) Switch F125 , removing and installing: Installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Location Of 10 Pin Harness Connector & Multi-Function Transmission Range (TR) Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect Multi-Function Transmission Range (TR) Switch F125 to shift rod. Flap part at splines in switch - 3 - must align with flat part of shift rod - 1 -.

NOTE:

Set Multi-Function Transmission Range (TR) Switch F125 onto shift rod in centered manner. Do not cant and do not set with force. Risk of damage at switch terminals.

Fig 2: Location Of 10 Pin Harness Connector & Multi-Function Transmission Range (TR) Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Rotate switch until the alignment bore - 4 - at switch housing can be fitted on the alignment pin - 2 - at transmission housing.
Installing left transmission support → Right and left transmission mounts, removing and installing .