ATF lines, removing and installing, (vehicles with 4 cyl. engine)

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Place drip tray VAG1306 underneath.

Fig 1: ATF Lines, Removing And Installing, Overview (Vehicles With 4-Cylinder Engine)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Bolt (21Nm)

Insert line until impact by hand before tightening

2 - Oil line to cooler

Note marking on transmission housing

3 - Oil line from cooler

Note marking on transmission housing

4 - O-ring

Apply ATF when inserting
Always replace

5 - O-ring

Apply ATF when inserting
Always replace

6 - Bolt (5Nm)

Insert line until impact by hand before tightening

7 - O-ring

Apply ATF when inserting
Always replace

8 - Bolt (5Nm)

Insert line until impact by hand before tightening

9 - Union nut - 29 Nm

10 - Bracket

11 - Hex bolt

Does not need to be removed when removing and installing ATF lines.

12 - Nut - 5 Nm

13 - Clamp

14 - Bracket

On engine/transmission support