Selector lever handle, removing and installing: Installing
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Installation is reverse of removal, noting the following:
- Shift selector lever into position "D".
NOTE:
- To install new selector lever knob - 3 - , button 2 must be pulled out as far as stop and secured with a cable tie - arrow - or using assembly aid included with new knob.
- If the button was accidentally not secured, then it must not be pulled from selector lever knob using mechanical tools. Apply compressed air gun to bottom of knob and carefully press button out with compressed air.
- Position complete selector lever knob - 3 - on selector lever - button 2 faces driver. During this, the knob must engage into ring groove of the selector lever.
- Remove cable tie - arrow - or assembly aid, then button actuation engages in vertical groove of selector lever. If necessary press button into selector lever knob.
- Pull sleeve - 1 - upward and engage by turning clockwise.