Locking cable, removing and installing: Removing
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Locking cable must not be kinked.
- Shift selector lever into position "S".
- Note radio code (for vehicles equipped with coded anti-theft radio/radio navigation system).
See Caution before beginning repairs on electrical system → Selector lever mechanism, servicing
- Disconnect Ground (GND) strap from battery.
- Remove storage compartment on drivers side →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
- Remove steering column cover: →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
- Remove air conditioning operating unit: → 87 AIR CONDITIONING
- Remove ashtray in center console: →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
- Remove shift mechanism cover → Shift mechanism cover, removing and installing .
- Switch ignition key to driving position (ignition on).
- Shift selector lever into position "P".
- Lift retaining clip - 2 - from interlock lever and pull locking cable - 1 - out of ignition/starter switch.
- Lift securing spring - 4 - for locking cable and pull locking cable support bracket - 5 - on shift mechanism sideways and disengage locking cable eye.