Locking cable, adjusting: Procedure
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove center console trim → Shift mechanism cover, removing and installing .
NOTE:
- Selector lever knob and cover can remain installed.
- Remove ashtray in center console: →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
Adjustment requirements:
- Locking cable in installation position
- Selector lever in position "P".
- Ignition key in removal position.
- Loosen bolt - 1 -.
- Support bracket - 2 - of locking cable must be movable by hand
- Push modified adjusting gauge 3352A between pin on lever for locking cable and locking cable eye.
- Move locking cable in direction of arrow to stop and tighten bolt - 1 - to 9 Nm.
- It must be possible to easily remove and insert adjusting gauge 3352A in this position.
- Remove adjusting gauge.
- Check ignition key removal lock after every adjustment of the locking cable → Ignition key removal lock, checking .