ATF level, checking: Notes
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Tester VAS5051
- Diagnostic cable VAS5051/1 or VAS5051/3
- Drip tray VAG1306
- ATF filler tool VAG1924
- Protective glasses
Test requirements:
- Transmission must not be in emergency running mode.
- Vehicle on level ground.
- Selector lever in "P" , let engine run at idle.
- A/C system and heating switched off.
NOTE:
- ATF level changes with ATF temperature.
- Performing ATF level check when ATF temperature is too low causes overfilling.
- Performing ATF level check when ATF temperature is too high causes insufficient filling.
- Excess filling and insufficient filling both affect the function of the transmission.
- ATF temperature is read off using the tester VAS5051.